LABVIEW SOFTWARE (one of SCADA system which can monitor and
controlling)
Design a circuit and program in labview
Features need to be added on the labview software:
- SET POINT (knob which control the voltage)
- DAQ ASSIST 1(acquired and transmit signal from output sensor)
- DAQ ASSIST 2 (generate voltage from DAQ card to the hardware)
- SIMULATE SIGNAL (PWM)
- WAVEFORM SENSOR
- WAVEFORM PWM
- CALCULATION
- PID (Compare and calculating the error continuously)
- CONSTANT(create value for PWM duty cycle)
- MEAN BLOCK (get the average result in order to get precise value)
- WIRING AND CONNECTION
No comments:
Post a Comment